Daiichi Seiko 01020 Rod Holder, Lark Rod Holder, 2000 for Boat Fishing, Black

This is a standard rod holder for cruisers and motorboats, equipped with a 3 stages of oscillating function at 90 degrees. Swings left and right, front and back with one touch of fingertips. For fishing boats that cannot be attached to a clamp-type rake rod holder. The rod holder can be fixed at 45° left and right to match the tide flow. This allows you to freely adjust the direction of the device to avoid straining. Installation Method 1 Mark the corners of the base of the 1 Lark 2000 at the front of the bail and place the 8 position of the base mounting hole with a pencil. Drill the 21 mark with the included drill and pinch the rubber seal and secure the base with the tapping screw. Installation Method 2 Insert the 3A rod holder into the base and then pass the B set pin. 4. Finally, you can fold the B-set pin and you're done. When moving the oscillating lock pin rod holder left or right, lift the oscillating lock pin and move the rod holder before inserting the lock pin into place. If the rod holder is not in use, you can remove the B set pin and remove the rod holder for storage.

• Support rod diameter: 1.3 inches (32 mm)
• Compatible Harris up to approximately No. 16
• Rod holder body, drill, bolt, rubber gasket base, 4.5 x 4.7 x 1.7 inches (114 x 120 x 43 mm)